Publicidad
Idiomas disponibles
Idiomas disponibles
13. Operations start procedure
Please wear suitable cloth and glove when operate this tool. Always check tools before use,
make sure on/off switch and safe switch are all ok. The power should be put off when you
loosen the trigger. Stop using the tool in case of switch failure. Always check rated voltage
of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure blade stop fully before
touch it, otherwise blade will hurt your body.
•
Pressthe power switch. After warning tone, please pull the trigger two times without holding. And
the shear will be on working condition after one more warning tone. Do not overload cutting, it
will protect pruning shear and battery not be damaged. Do not cutting over the dimension specified
in the technical information table.
•
User just loose trigger when the blade has been jammed by branch, the blade will resume maximum
position.
Caution: Do not sway the pruner from the left to right in order not to damage the edge of
blade during the resume process of blade.
Check the working frequency of the blade in order to verify the good working condition.
14. Cutting
Wear suitable work clothes such as
boots with non-slip soles, sturdy long
trousers, gloves and goggles.
Wear protection gloves
Warning!
In particular situations of very hard use, the blade and the handle could reach high temperatures. It is
recommended to handle the pruner with care, using protective gloves.
•
When ready to cut, place the blade on the branch to be cut and press the trigger;
32
Wear eye protection
Risk of cutting and severe injuries
Publicidad
