Motorola Talkabout TA288 Manual De Instrucciones página 6

AA Battery Type Selection:
To ensure that the Battery Meter icon is showing accurate battery
usage when using AA batteries, the type of battery being used in your
walkie-talkie should be set, in the AA Battery Type Selection menu, to
the correct battery type.
12
1. Press the Menu button seven times to enter the AA Battery Type
Selection menu. (This menu is only accessible if AA batteries are
being used).
2. The Battery Meter icon will flash and either a
replace the large channel number.
10
3. Use the Scroll button to choose either a
are being used or , if NiCd or NiMH
AA batteries are being used.
4. The walkie-talkie will return to the normal operating mode after a
11
few seconds or when you press the Mon button.
Note: Remove batteries before storing your walkie-talkie for extended periods.
Batteries corrode over time and may cause permanent damage to
your walkie-talkie.
Belt Clip
Talkabout TA288 walkie-talkies come standard with a belt clip which
E
can be used with both the NiMH and AA battery covers.
To Attach:
1. Insert the base of the walkie-talkie in bottom portion of the belt clip.
F
2. Push the walkie-talkie towards the belt clip until it latches into place.
3. To remove the walkie-talkie from the belt clip, gently but firmly
G
pull the top of the belt clip away from the walkie-talkie.
English 2
or a will
, if Alkaline batteries
Before You Can Talk
Read this manual carefully to make sure you know how to properly
operate the walkie-talkie before use.
Talkabout TA288 walkie-talkies have 8 channels and 38 Interference
Eliminator Codes. To talk to others, all walkie-talkies in your group
must be set to the same channel and code.
Interference Eliminator Codes filter out static, noise and unwanted
messages on walkie-talkie channels. You can only communicate with
walkie-talkies using the same channel and code. However, since
walkie-talkie channels can be monitored, conversations are not
private. To avoid congested channels, change the walkie-talkie's
channel/code setting. (Ensure all other walkie-talkies in your group
are also changed).
Change The Channel:
1. Press the Menu button once to enter the Channel Selection Menu.
2
The channel number will begin to flash.
2. Use the Scroll button to select a new channel while the channel
number is flashing.
3. The walkie-talkie will return to the normal operating mode after a
few seconds or when you press the Mon button.
Change The Code:
1. Press the Menu button twice to enter the Code Selection Menu.
3
2. The walkie-talkie's current code (small number) will begin to flash.
3. Use the Scroll button to select a new code while the number is
flashing.
4. The walkie-talkie will return to the normal operating mode after a
few seconds or when you press the Mon button.