Trust START-LINE SET ACDB-9000AC Manual De Instrucciones página 9

6B. Securing push button with screws
A
Insert a flathead screwdriver into the notch on the
bottom of the push button and slide the push button
off the back plate
B
Determine where the push button will be placed and
secure the back plate with the supplied screws.
C
Place the push button back on the back plate by sliding
it from top to bottom.
Unpair a Trust Smart Home transmitter
A
Press the connect button for 1 second. The learning
mode will be active for 10 seconds and the LED indicator
on the receiver will blink slowly.
B
While the learning mode is active, send an ON signal
with the channel of the paired Trust Smart Home
transmitter you want to disconnect
C
To confirm, the wireless doorbell will give 2 short beeps.
Erasing the entire memory
A
Press the connect button (8 seconds) until the LED
indicator starts flashing rapidly. The reset mode will
be active for 10 seconds and the LED indicator on the
receiver will flash rapidly.
B
While the reset mode is active, press the learn button
again for 1 second to confirm that you want to delete
the memory completely.
C
To confirm, the wireless doorbell give 2 short beeps
Replacing the doorbell batteries
When the batteries are low, the LED on the doorbell
will flash every 10 seconds. In this case, replace the
batteries. If you replace the doorbell batteries, the paired
transmitters will remain in its memory.
ACDB-9000AC PORTABLE WIRELESS DOORBELL SET
A
Open the doorbell battery compartment by twisting the
bottom open towards the open lock icon.
B
Insert two 1.5V AA alkaline batteries (not included) as
shown. Be sure to pay attention to the correct polarity
of the batteries (place plus and minus on the right side).
C
Place the bottom cover back on the doorbell.
Make sure that the line on the bottom of the doorbell
is in line with the open lock icon. Then turn the bottom
side to the closed lock icon.
Changing the battery of the push button
A
When the battery is low, the LED will light up for 2 sec
and then blink 3 times after pressing the push button.
Insert a flat screwdriver into the notch on the bottom
of the push-button and slide the push-button off the
back plate.
B
Open the waterproof rubber to reveal the battery
C
Remove the old battery and insert a new CR2032
battery into the recess of the battery holder. Make sure
the + is pointing upwards.
C
Close the waterproof rubber and place the push button
back on the back plate.
Combine the push button with the Internet
Control Station (ICS-2000) or Smart Bridge
Combine the push button with the Internet Control
Station (ICS-2000) or Smart Bridge and also receive a push
notification on your smartphone when the doorbell rings.
For example, you can turn the wireless doorbell off at
night and only receive a push notification when the push
button is pressed.
EN
9