Publicidad
Idiomas disponibles
Idiomas disponibles
with "Lo") or if nothing appears on the display
switched on, you have to recharge the battery in order to ensure further
operability. When the battery is fully charged and 3 blood pressure
measurements are carried out per day, the energy is sufficient for around
20 days of service.
WARNING - BATTERY SAFETY INFORMATION
• Do not disassemble batteries!
• Increased risk of leakage, avoid contact with skin, eyes and
mucous membranes! If battery acid comes in contact with
any of these parts, rinse the affected area with copious
amounts of fresh water and seek medical attention imme-
diately!
• If a battery has been swallowed seek medical attention
immediately!
• Keep batteries out of children's reach!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Do not throw used batteries into the household refuse; put
them in a hazardous waste container or take them to a
battery collection point, at the shop where they were
purchased!
• The battery of this device must only be exchanged by
specialized personnel. Never try to disassemble the battery
on your own, but contact the service centre!
3.3 Setting the date and time
1.
Before using the unit, you need to put the LOCK-switch
"ON" (green). In "OFF" (red) - position the Bluetooth function is de-
activated and all buttons are locked.
2.
Press and hold the S-button
3.
Firstly, the date figure starts to flash. Press M-button
actual month.
4.
Press the S-button
5.
Now the day figure starts flashing. Proceed accordingly for the input of
day, year, hour and minute (as described under point 3 and 4).
6.
On completion of the date and time setting, "Ok" appears on the dis-
play. The unit switches off automatically after about 60 seconds, if no
buttons are pressed in order to save power.
3.4 Setting up the user memory
The MEDISANA Wrist blood pressure monitor SL 100 connect gives
you the opportunity to assign readings to one of two user memories, each
of which provides 500 memory slots. Press and hold the M-button
least 3 seconds, until the symbol for User 1
By pressing M-button
If you choose "Guest", the values of the reading will not be saved.
Press the S-button
for at least 3 seconds.
to confirm the setting.
you can switch User 1 and User 2 or Guest
to confirm your selection.
3 Getting started
after the unit has been
to position
to adjust the
appears in the display.
GB
i
i
i
i
i
for at
.
i
23
Publicidad
