MIRKA DEOS 343 Instrucciones De Manejo página 57

Remove
1. Turn the tool upside down.
Remove the 4 screws (A).
2.
3. Remove the 4 screws (B).
4. Remove the backing pad.
Install
1. Fit the new pad.
2. Fit the 4 screws (B).
Fit the 4 screws (A).
3.
Finally tighten all screws.
4.
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and continuously
with net products. These cost effective pad savers, placed between the backing pad and the sanding disc, should be
changed regularly. The pad savers prolong the life of the backing pad.
https://www.mirka.com/accessories/pad-savers/
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service or your Mirka dealer.
Troubleshooting guide
Symptom
The sander LED (right) flashes
between red and green.
No light from Sander LED (right)
when switched on.
The sander LED (right) is red and the
sander slows down to 5,000 rpm
when sanding.
The sander LED (right) is red and
rpm is slightly reduced.
Possible cause
Connected to a mains outlet with
wrong voltage.
Power cord not properly attached to
the sander or to the mains socket.
Temperature too high in the sander.
Too heavy long term load.
Too heavy short term load.
Solution
Connect the sander to a mains outlet
that correspond with the nominal
voltage of the tool.
Connect it properly.
Reduce the load on the sander for
some time and the sander will speed
up again.
Use lighter load and the LED (right)
will automatically change to green.
Mirka® DEOS 343, 353, 383 & 663
en (original)
57