Publicidad
Idiomas disponibles
Idiomas disponibles
Install Washing Machine
■ Remove transit bolts
Before using this washing machine,transit bolts must be removed from the
backside of this machine.Please take the following steps to remove the
bolts:
&.
Keep the transit bolts properly for futher use .
....
1.Loosen the four transit
bolts with a spanner
■ Level the washing machine
Install or place the washing machine under the environmental temperature
of not less than 0
controller.
Base foot struc
Lock nut
Support foot covered
with rubber
&.
Note:ln
order to
locked,please
1.When placing the machine,check whether
the bottom foot is in the factory state.if
not,please restore the bottom foot to the
factory state:the locking
nut is locked tightly on bottom of
the box,and the support foot is locked
lightly on the locking nut:
3.To ensure that the machine is placed in the right
state, loosen the locking nut according to the direction
shown in the diagram with the attached spanner to the
appropriate height until the supporting foot is close to
the ground and the machine is free from shaking
........
Iba
--- •
1. The machine must be perfectly leveled and stabilized when the four
supporting feet are close to the ground. Lower the feet as much as possible
on the basis that the machine is leveled.
2. lmproper leveling adjustment may cause loud noise, machine vibrating,
machine displacement and other abnormal phenomena.
3. Air-vent is designed on the bottom of the machine (prevent blockage). Install
the washing machine on solid, smooth and skid-proof ground. Do not place
the washing machine on soft blanket or wooden floor, or various desktops
and stands, in case of unnecessary injury.
...
2.Take each bolt head and pull it through the
wide part of the hole. Repeat for each bolt.
:l
°
C but not outdoors, for it may damage the programming
umre
:'"
facilitate
installation,the
be sure
to lock all
four feet
\
�
-
Support base is close
�
to the round
...
...
�
Factory status
■
Locking nut close
�
to bottom of box
6'
■
Supporting foot close
'---------------'
to locking nut
factory
status
before
adjusting
2.Afler the machine is placed,press the opposite
corner of the top cover plate of the washing
machine with both hands in turn
•
and shake it vertically downward
to check whether the supporting
foot is close to the ground and
whether the machine is shaken
4.Finally,use the spanner to turn the lock nut back
to thebottom of the box to lock il(you can also
slightly fix the support foot by hand to avoid the
support foot moving again)
Ensure that the supporting
feet do not move again
8
3.Fill the holes with the
supplied plastic covers.
11111•1::::-:::::::-
of the
foot
may not be all
the
level
- - - - /
�
,
_ _
• -
V.1
Publicidad
