Publicidad
Idiomas disponibles
Idiomas disponibles
Connect the inlet hose
1.Connect the inlet hose to tap and
fasten it anticlockwise.
2.Connect the other end of the inlet hose to the inlet valve at the backside of the
washing machine and fasten the hose tightly clockwise.
when there is a inlet at the back of the machine,it must be connected to a cold
water supply.If there are two inlet valve,one is connected to a cold water
supply and the other is connected to a hot water supply. Follow the indication
of the picture below to complete the connection.
inlet valve for cold water
inlet hose for cold water
NOTE
• If there is any leakage with hose after the
connection,then repeat the steps to connect
inlet hose.
• Do not bend the hose.
• Check for inlet hose connection carefully
before using the washer each time.
Connect the drain hose
• The drain hose shall be placed at a height of
65-100cm above the floor, otherwise,it can
cause poor drainage
• You can use the supplied drain hose support
bracket to loop the drain hose down into the
wall,standpipe or laundry tub.
• Take care to ensure all hose connections are
tight.
NOTE
The end of the drain hose cannot be
immersed in water for the washer to work
properly.
inlet valve for hot water with a red grid
inlet hose for hot water with a red side
9
V.1
Publicidad
