How To Set Up Louver Lock (No Swing) - Toshiba RAV-SM564UT-E Manual Del Propietário

4-way Air Discharge Cassette Type

How to set up louver lock (No swing)

1
Push
at least four seconds when the air
conditioner is not working.
• , symbol, and numbers flash.
2
Select an indoor unit to be set by
pushing
• Each time you push the button, unit
numbers change as follows:
The fan of the selected unit runs and the
louvers start swinging.
Unit No.
1-1
3
Display the number of a louver you want to
lock on the temperature display section by
pushing TEMP.
• The selected louver starts swinging.
4
Select the wind direction of the louver
you do not want to swing by pushing
TIME
(1)
CODE
0001
(4)
0004
3
4
(right side of the button) for
(left side of the button).
Unit No. Unit No.
1-2 1-3
Unit No.
1-4
buttons.
buttons.
(2) (3)
0002 0003
(5)
0005
2 1
• When (4) or (5) is selected, dew drop may occur
during cooling mode.
5
Determine the setting by pushing
button.
• When the setting has been determined,
lights up.
(To continue louver lock settings for other
indoor units, repeat from step 2. To
continue louver lock settings for other
louvers on the same indoor unit, repeat
from step 3.)
6
Push button to complete the setting.
• A louver number is displayed as F1, F2 on
the remote controller (Item Code), showing
that louver 01, 02 shown in the figure on the
previous page is selected.
NOTE
Even when louvers are locked, they move
temporarily in the following cases:
• While the air conditioner is stopping
• At the beginning of heating operation
• During defrosting operation
• When the room temperature reached the set
temperature
– 16 –
Owner's Manual
CAUTION
0001-0005
(Louver lock position code)
EN
16-EN