Periodic Maintenance Schedule - Ryobi GD200 Manual Del Operador

REPLACING CAR REMOTE BATTERIES
See Figure 83.
WARNING:
KEEP OUT OF REACH OF CHILDREN.
batteries may lead to serious injury or death.
WARNING:
Risk of injury due to fire, explosion, or leakage. Do not
disassemble, charge, crush, or expose to fire or high
temperatures.
 Remove visor clip.
 Remove the battery cover by inserting the edge of a coin
into the slot and twisting.
 Install the battery or batteries according to the polarity
indicators.
NOTE: The remote can be powered by one 2032-size
battery, or two 2016-size batteries stacked together.
 Reassemble the remote by aligning the sections as
shown.
Each Week  Check the power head, rail, brackets, door arms, track, and rollers for loose or damaged parts.
Each Month  Manually open and close the garage door. If the door does not move smoothly, binds, or is out
 Test the automatic reversal system as described in the Installation section.
Every 3 Months  Test the travel limits of the garage door, as described in the Operation section, and ensure it
 Check the condition of the power suppy cord and battery pack. Replace as needed.
Each Year  Lubricate the garage door rollers and hinges. The garage door opener is lubricated with a sufficient
 Unplug the power head and test the battery backup. If the unit cannot run on DC power alone,
MAINTENANCE
Swallowing

PERIODIC MAINTENANCE SCHEDULE

Replace or tighten as needed.
of balance, have the garage door or door springs repaired by a qualified service person.
opens and closes fully.
amount of lubricant for the life of the unit under normal operating conditions. Therefore, no further
lubrication of the unit is required. DO NOT ADD LUBRICANT TO TRACKS.
charge or replace the battery pack.
 Snap the sections together to close.
 Make sure the remote is securely reassembled before
attaching the visor clip.
Coin
48 - English
Visor
Clip
Batteries
OR
Fig. 83