Klarstein IGNITO 4 Manual página 33

install a hob above it.
• Check the dimensions of the oven in the installation manual.
• The cut out size must obey the indication.
1. Remove the pan supports, the burner lid
and flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices
and flame supervision devices are not
damaged in this operation.
2. Apply the sponge provided around the
edge of the appliance.
3. Do not leave a gap in the sealing agent or
overlap the thickness.
Sponge
The thickness of the sponge is 3 mm.
The width of the sponge is 10 mm.
Do not use a silicon sealant to seal the
appliance against the aperture This will make
it difficult to remove the appliance from the
aperture in future, particularly if it needs to be
serviced.Do not use a silicon sealant to seal
theappliance against the aperture.
1. Place the bracket (B) over the holes that
match the size of the screws.There are one
set of screw holes in each corner of the
hob (H)
Slightly tighten a screw (C) through the
bracket (B) so that the bracket is attached
to the hob, but so that you can still adjust
the position .
2. Carefully turn the hob back over and then
gently lower it into the aperture hole that
you have cut out.
3. On the underneath of the hob, adjust the
brackets into a position that is suitable for
your worktop. Then fully tighten the screws
(C) to secure the hob into position.
(A) SEALING STRIP
(C) SCREW (B) BRACKET
EN
33