Fanimation The Cancun FP8012 Serie Manual Del Propietário página 8

Installing the Canopy Housing (continued)
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the key slot twist-lock feature. (Figure 15)
1. Remove and discard the five rubber motor stops
from the motor assembly by removing the screws.
(Figure 16)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade arm. With
a Phillips screwdriver, tighten 3/16-24x7.5 mm phillips
head screws with flat washers to secure the blade to
the blade arm. (Figure 17)
3. Attach blade holders to the motor hub using the
1/4-20x14 mm screws. (Figure 18)
NOTE: Periodically check blade holder hardware and
resecure if necessary.
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
How to Assemble the Blades
8
Figure 15
Figure 16
3/16-24 x 7.5mm Phillips
Head Screw and Flat
Washer (3 each per blade)
BLADE HOLDER
Figure 17
HARDWARE USED:
3/16-24 x 7.5 mm
PHILLIPS-HEAD
SCREWS
FLAT WASHER
Figure 18
HARDWARE USED:
1/4-20 x 14 mm
SCREWS
CANOPY SCREW
COVER
BLADE
X 15
X 15
1/4-20 x 14 mm
SCREWS
(2 per assembly)
BLADE
HOLDER
X 10