Electronic Adjustment; Use Of Dishwasher Salt - Zanussi ZDF4010 Manual De Instrucciones

1

Electronic adjustment

The water softener is set at the factory at level 5.
1. Switch on the appliance.

Use of dishwasher salt

Caution! Only use dishwashers salt. Types of salt
that are not applicable for dishwashers cause
damage to the water softener.
1
3
Fill the salt container with
1 litre of water (only the
first operation).
2
Set switch to position 1 or
2.
2
4
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the
indicator lights of function buttons A, B and C start
to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator lights for function buttons B and C
go off.
– The indicator light for function button A continues
to flash.
– The digital display shows the current level.
Example: digital display shows
6. Press the function button A one time to increase the
water softener level by one step.
7. Press the on/off button to save the operation.
5
It is normal that water overflows from the salt con-
tainer when you fill it with salt.
Make sure that there is no grain of salt outer of the
salt compartment. Salt which stays on the tank for
a while drills the tank. It is recommended to start a wash-
ing programme immediately after you fill the salt con-
tainer. This prevents of corrosion because of spilled salt.
When you set electronically the water softener to level 1,
the salt indicator light does not stay on.
= level 5.
6
23