Setting And Starting A Washing Programme; Cancelling A Washing Programme - Zanussi ZDF4010 Manual De Instrucciones

Activate or deactivate the multitab function before
the start of a washing programme.
You cannot activate or deactivate the multitab function
when the programme operates. Cancel the washing pro-
gramme, then set the programme again.
To activate the multitab function:
• Press and hold the two multitab buttons (function but-
tons D and E). The multitab indicator light comes on.
To deactivate the multitab function:
• Press and hold the two multitab buttons (function but-
tons D and E). The multitab indicator light goes off.
Do these steps if the drying results are not satis-
factory:
1. Fill the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
• You can only activate or deactivate the rinse aid dis-
penser when the multitab function is activated.
To activate/deactivate the rinse aid dispenser:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons A, B, and
C start to flash.

Setting and starting a washing programme

Set the washing programme with the door ajar. The
washing programme only starts after you close the
door. Until then it is possible to modify the settings.
Do these steps to set and start a washing programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press one of the programme buttons. Refer to the
chapter 'Washing programmes'.
– The programme indicator light comes on.
– All other programme indicator lights go off.
– The digital display shows in flashing the pro-
gramme duration.
– The programme-in-progress indicator light
comes on.
4. Close the door.
– The washing programme starts automatically.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons A and C
go off.
– The indicator light for function button B continues
to flash.
– The digital display shows the setting.
6. Press function button B again.
– The digital display shows the new setting.
7. Switch off the appliance to save the operation.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid dispenser.
3. Adjust the water hardness setting to the highest level.
4. Do a washing programme without dishes.
5. Adjust the water softener to the water hardness in your
area.
6. Adjust the rinse aid dosage.
– The programme-in-progress indicator light re-
mains on.
When the washing programme operates, you cannot
change the programme. Cancel the washing pro-
gramme.
You can select the washing programme and delay
start also with the door closed. When you press a
programme button you have only 3 seconds to select a
different washing programme or a delay start. After these
3 seconds, the selected programme starts automatically.
Warning! Only interrupt or cancel a washing
programme if necessary.
Caution! Open the door carefully. Hot steam can
come free.

Cancelling a washing programme

1. Press and hold function buttons B and C until:
Rinse aid dispenser deac-
tivated
Rinse aid dispenser activa-
ted
27