TME MM2030 Manual Del Usuario página 2

GB
English
Introduction
Your high accuracy microprocessor driven thermometer is
suitable for use with thermocouple types K,J,T,R,N,E,S or
Infra-Red sensors.
The thermocouple calibrations are in accordance with
national and international standards (NBS and IEC) tables.
Features
•
°C / °F/ °A TEMPERATURE SCALES
•
MEASURE TEMPERATURE
•
SIMULATE THERMOCOUPLE
•
OVERRANGE / OPENCIRCUIT PROBE INDICATION
•
LOW BATTERY INDICATION
•
K,J,T,R,N,E,S THERMOCOUPLE TYPES
•
Milli-Volt MEASUREMENT OUTPUT.
•
RETENTION OF THERMOCOUPLE TYPE AND SCALE
fig 1
SIMULATION INDICATOR BARS
MAIN DISPLAY
BATTERY LOW INDICATION
2
TEMPERATURE SCALE
SECOND DISPLAY
THERMOCOUPLE TYPE
OPERATING INSTRUCTIONS
To Measure Temperature
1. Fit the battery to the instrument
(refer to battery replacement details)
2. Switch thermometer ON.
3. Plug thermocouple into input socket.
4. Check temperature scale is correct.
5. Check thermocouple is correct
6. Take measurement by contacting object with probe and
reading from the display.
Changing Temperature Scale (°C / °F/ °A)
To change the temperature scale simply press the button
marked 'SCL'
The temperature scale will alter as shown on the right
hand side of the display.
Changing Thermocouple Type
To change thermocouple type, follow the sequence below:
1. Switch the unit OFF.
2. Press and hold the 'SCL' button.
3. Switch the unit ON.
4. Release buttons.
Note
MilliVolt function is selected as if it were a thermocouple
type.
The new thermocouple type will appear in the bottom
right hand corner of the display (see fig 1). Repeat steps
above until desired thermocouple type is shown.
MM2030
(°C / °F/ °A)
3