Publicidad
Sl4018
14
opERATING ThE Tool
TESTING ThE Tool
1
ƒ Disconnect air hose from the tool.
ƒ Remove all fasteners from the tool.
ƒ ALL SCREWS MUST BE TIGHTENED.
ƒ If any screws are loose, tighten them.
ƒ ThE SAfETY/pUSh lEVER AND TRIGGER MUST
MoVE SMooThlY.
ƒ Adjust the air pressure to 70psi.
ƒ Connect the air hose.
ƒ Do not load any fasteners in the tool.
ƒ ThE Tool MUST NoT lEAK AIR.
ƒ Remove finger from the trigger and press the safety/
push lever against the wood.
ƒ ThE Tool MUST NoT opERATE.
2
ƒ Separate the safety/push lever from the wood.
ƒ Next, point the tool in a safe position, pull the trigger and
then hold that position for 5 seconds or longer.
ƒ ThE Tool MUST NoT opERATE.
ƒ Without touching the trigger, depress the safety/push
lever against the work piece.
1
ƒ Pull the trigger.
ƒ ThE Tool MUST opERATE If SET IN SEQUENTIAl
fIRE MoDE.
ƒ Hold the trigger back while separating the safety/push
lever from the wood.
2
ƒ Remove finger from the trigger.
ƒ Tool opERATIoN WIll END.
ƒ (the driver blade will return to the top).
ƒ With the tool off the work piece, pull the trigger.
ƒ Depress the safety/push lever against the work piece.
ƒ ThE Tool MUST opERATE If SET IN bUMp fIRE
MoDE.
Interchange Brands Staplers: Operator's Manual
Publicidad
