Publicidad
SL4018
Wheel to
adjust
depth of
drive
6
opERATING ThE Tool
1
STAplE loADING
1
ƒ Keep stapler pointed downward.
ƒ Pull the staple feeder backward until it latches.
2
ƒ Place the staple strip onto the rail of the magazine.
Make sure that the staple strip slides freely on the
3
magazine.
ƒ Do not load with safety or trigger depressed.
ƒ Release the feeder from the latch and gently allow it to
move forward.
ƒ The stapler is now ready to operate.
CAUTIoN:
ƒ A staple can be driven unintentionally if the trigger and
safety bracket are activated at the same time. Always
2
disconnect the stapler from the air supply prior to
loading staples, making any adjustments, or performing
any service on the stapler. Remember to keep finger off
the trigger until you are ready to drive a fastener.
ƒ Be sure to bring back the staple feeder, avoiding any
impact.
ƒ Never connect stapler to pressure that potentially
exceeds 110psi.
ƒ Never use non-relieving coupler on stapler.
ƒ Never use oxygen or other bottled gases, as an
explosion may occur.
3
ADjUSTING ThE DEpTh
4
4
ƒ To drive the staple shallower, turn the wheel to the right
to the extent desired.
ƒ To sink a staple deeper, turn the wheel to the left to the
extent desired.
ƒ Make sure that the trigger and safety move freely up and
down without binding or stickng after each adjustment.
Deeper
Drive
Interchange Brands Staplers: Operator's Manual
Shallower
Drive
Publicidad
