Hilti SIW 6 AT-A22 Manual De Instrucciones Original página 14

5.1.4 Fitting the belt hook (optional)
The belt hook enables you to attach suitable power tools to your belt. It can
be fitted to allow attachment on the left or right side of the body.
CAUTION
Risk of injury by falling power tools!
▶ Check that the belt hook is fitted securely before beginning work.
1. Fit the belt hook.
2. Attach your power tool to the belt hook.
3. Check that belt hook and power tool are secure.
5.1.5 Fitting an accessory tool
CAUTION
Risk of injury through use of the wrong type of accessory tool!
▶ Use only accessory tools of the locking type.
▶ Do not use worn or damaged accessory tools.
1. Clean the connection end of the accessory tool.
2. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
3. Bring the notch in the accessory tool into alignment with the ball on the
square drive.
4. Push the accessory tool onto the square drive until it engages.
5. Allow the accessory tool to engage and check that it is held securely.
5.1.6 Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when using the power tool and when changing
accessory tools.
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the accessory tool off the square drive.
5.1.7 Setting the torque
▶ Select one of the following alternatives:
5.1.7.1 Operation without the intelligent torque module
▶ Push the torque selector button repeatedly until the desired torque setting
is displayed in the torque display.
5.1.7.2 Operation with the intelligent torque module
"AT" lights in the torque display (intelligent torque mode).
10 English
2
3
2124662
*2124662*