Hilti SIW 6 AT-A22 Manual De Instrucciones Original página 17

7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of
transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by
children or unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of
storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
When operating the impact screwdriver with the intelligent torque
module SI­AT­A22, make sure that you also read the notes on remedying
possible faults in the operating instructions for the torque module.
Trouble or fault
The power tool
doesn't run.
The power tool
doesn't work and
the battery charge
status display blinks.
*2124662*
Possible cause
The battery is not fully
inserted.
Low battery.
The battery is too hot or
too cold.
2124662
Action to be taken
▶ Push the battery in
until it engages with
an audible double
click.
▶ Change the battery
and charge the empty
battery.
▶ Bring the battery to
the recommended op-
erating temperature.
English 13