Kuppersbusch DEF6300.0 Instrucciones De Uso página 20

anchor points of the activated charcoal
filter and turn it clockwise.
 The carbon filter lasts from three to six
months depending
conditions of use.
Dimensions:
Width = 600/ 900 mm
Depth = 300 mm
Height = 183/ 273 mm
To fix the cooker hood please choose one of
the following options:
a) Fixing to the upper part of the furniture:
Figure 4 must be used where the position
of the holes is indicated.
b) To the internal side of the furniture:
When the body of the hood fits within the
furniture, fasten with two screws on each
side from the inside of the body, using the
side holes.
The lower part of the extractor must be
located at a minimum height of 60 cm above
the hob for electric cookers and 65 cm for gas
cookers. If the instructions of a gas cooker
indicate a greater distance these must be
observed.
Before seeking technical assistance carry out the following checks first:
Defect
The extractor does not
work
The extractor does not
blow enough
vibrates
20
on the particular
Possible cause
The cable is not connected
No current is reaching the
plug
Filter saturated with grease
Outlet obstructed
or
Inadequate air conduit
 The activated carbon filter can neither be
washed nor regenerated. Once it is
exhausted, it must be changed.
 To replace exhausted filters with new ones,
withdraw the old one in the reverse order
to that of installation.
Electrical characteristics:
REFER TO RATING PLATE
To achieve optimum performance the length of
the outlet hose should not exceed 4 meters, or
include more than two 90º angles (elbows).
Although venting
recommended, activated carbon filters may be
used, which allow the gas to be returned to
the kitchen through the outlet pipe.
If you wish to exchange the front for one
matching the kitchen units, follow the following
instructions (Fig. 3):
 Withdraw the movable group.
 Remove the screws (T) that support the
front.
 Install the new front fixing it with the same
screws that held the old one.
Solution
Connect the mains cable
Revise/repair the electricity circuit
Clean or substitute the filter
Eliminate obstructions
Contact the installer and follow instructions of
this manual
to the outside is