Publicidad
Idiomas disponibles
Idiomas disponibles
1. Prepare cabinet cutout.
Prepare cabinet cutout and install electrical connection
according to the dimensions in "General Information".
2. Remove the drawer from the drawer housing.
a
Pull drawer to fully open position.
b
Press down right drawer release lever.
c
Lift up left drawer release lever.
d
Firmly pull the drawer straight out. Retract cabinet
rails while drawer is removed.
5. Postion the storage drawer housing in front of the
cabinet where it is to be installed. Position the
Microwave or Steam Oven nearby.
6. The storage drawer is ready for the Microwave or
Steam oven to be mounted on it.
Mounting the Microwave on the Storage
Drawer
Assemble the Brackets to the Storage Drawer
Note: Do not place the storage drawer into the wall cabinet
until after mounting the microwave on it using the universal
connector brackets.
1. Attach both universal connector brackets to the storage
drawer housing using three of the screws provided for
each bracket. Tighten screws securely, but do not
overtighten.
Note: The universal connector brackets are interchange-
able for the left and right sides of the storage drawer. Be
sure the taller vertical edge of the bracket is positioned to
the outside of the storage drawer.
1. Place the microwave oven unit on top of the universal
connector brackets and fasten in place using three
screws per side in the outside set of holes (A). Tighten
the screws securely, but do not overtighten.
Note: The existing screws in the microwave base help
with alignment. When lowering the microwave into
place on the universal connector bracket allow these
screw heads to slide into the slots as shown in the
illustration below. The screw nearest the front of the
microwave slides into the base of the slope at the front
of the bracket.
2. Continue with the unit installation in the section below
describing installation of the storage drawer
microwave/steam oven unit into the wall cabinet.
English 3
Publicidad
