Bosch HSD30 Manual página 6

Mounting the Steam Oven on the Storage
Drawer
Note: Do not place the storage drawer into the wall cabinet
until after mounting the steam oven on it using the universal
connector brackets.
1. Attach both universal connector brackets to the storage
drawer housing using six of the screws provided into
the inner set of holes (B). Tighten screws securely, but
do not overtighten.
Note: The universal connector brackets are interchange-
able for the left and right sides of the storage drawer. Be
sure the taller vertical edge of the bracket is positioned to
the outside of the storage drawer.
2. Place the steam oven unit on top of the universal
connector brackets and fasten in place using two
screws per side. Tighten the screws securely, but do
not overtighten.
Note: The existing screws in the sides of the steam
oven base help with alignment. When lowering the
steam oven into place on the universal connector
bracket allow these screw heads to slide into the slots
as shown in the illustration below. The screw nearest
the front of the steam oven slides into the base of the
slope at the front of the bracket.
English 4
3. Continue with the unit installation in the following
sections on electrical connection and installing the
steam oven/storage drawer unit into the wall cabinet.
Electrical Connection
1. Refer to the Steam Oven or Microwave installation
manual for the relevant instructions for connection to
the power supply junction box.
Installation into the Cabinet Cutout
1. Install the storage drawer and Steam Oven or
Microwave assembly into the cabinet cutout.
9 CAUTION
It is recommended to have 2 installers to install the
unit assembly. Failure to do so may result in
property damage or personal injury.
Slide the assembly into the cabinet cutout until it is
flush with front of the cabinet. Secure through screw
holes in cleats (drill pilot holes in cleats first if
necessary). See installation dimensions diagram.
Secure microwave/steam oven according to installation
instructions provided with those units.
2. Replace drawer.
• Be sure cabinet rails are pushed inside cabinet.
• Align the rails on the drawer rails with the rails
attached to the drawer housing.
• Firmly push the drawer straight into the drawer
housing until the drawer clicks into place. The
drawer should insert easily. If it binds, do not
attempt to force it. Remove the drawer, align the
slides on the housing to the front edge of the
housing and try again. Slide the drawer into both
housing slides at the same time, and keep the
drawer level while doing so.
• Open and close drawer to test operation. Note: if
the drawer will not close, verify that the rail release
levers are properly positioned.
3. Turn power on at the service panel.
4. Test the installation.