Black and Decker BDCSFS30 Manual De Instrucciones página 10

English
• Install the storage case by sliding it into the foot of
the screwdriver.
NOTE: Do not open storage case while attached to
screwdriver. First remove storage case from the screwdriver
and then open.
Fig. G
SCREW DRIVING
For driving fasteners, the forward/reverse/lock-off slider
should be pushed to the left. Use reverse (slider pushed to
the right) for removing fasteners. When moving from forward
to reverse, or vice versa, always release the trigger first.
Release trigger when the fastener is at the desired depth.
Troubleshooting Guide
BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest
you or call the BLACK+DECKER help line at 1-800-544-6986.
PROBLEM
- Unit will not start.
- Battery will not charge.
- Unit shuts off abruptly.
8
NOTE: For best performance, #8, 2" fasteners are
recommended, or screw into pre-drilled holes (1/16 - 5/32
bit recommended).
DRILLING
•
•
GENERAL DRILLING TIPS
•
•
•
10
•
•
•
•
•
•
DO NOT CLICK THE TRIGGER OF A STALLED TOOL OFF AND
ON IN AN ATTEMPT TO START IT. DAMAGE TO THE TOOL
CAN RESULT. To remove:
POSSIBLE CAUSE
- Battery pack not charged.
- Internal componets too hot.
- Jack plug not inserted
into charge port.
- Charger not plugged in.
- Surrounding air temperature
too hot or too cold.
- Battery has reached its
maximum thermal limit.
Out of charge. (To maximize
-
the life of the battery pack it is
designed to shut off abruptly
when the charge is depleted.)
Insert the appropriate hex shank drill bit.
Select forward rotation.
This tool is not recommended for drilling in masonry.
Use sharp drill bits only
Drill bits for metal can be used for drilling holes in wood.
These bits must be sharp and should be pulled out
frequently when drilling to clear chips from the flutes.
Support and secure work properly, as instructed in the
safety Instructions.
Use appropriate and required safety equipment, as
instructed in the safety instructions.
Secure and maintain work area, as instructed in the
safety instructions.
Use light pressure until the hole is started enough to
keep the drill bit from slipping out of it.
Apply pressure in a straight line with the bit. Use
enough pressure to keep the bit biting but not so much
as to stall the motor or deflect the bit.
Hold the tool firmly to control its twisting action.
• Put tool in reverse and back drill bit out.
POSSIBLE SOLUTION
- Check battery pack
charging requirements.
- Allow tool to cool down.
- Insert jack plug into charge port.
- Plug charger into a working
outlet. Refer to "Important
charging notes" for
more details.
- Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4,5°C) or below 105
degrees F (+40,5°C).
- Allow tool to cool down.
- Insert jack plug into charge
port and allow to charge.