Clean And Maintenance - Orbegozo EX 5000 Manual De Instrucciones

EX 5000
FROTHING MILK / MAKE CAPPUCCINO
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Method:
1. Prepare espresso first with container big enough according to the part "MAKE ESPRESSO COFFEE", make
sure that the function knob is on "
2. Press the heating button "
3. Fill a jug with about 150 grams of milk for each cappuccino to be prepared, you are recommended to
use whole milk at refrigerator temperature (not hot!).
Note: for jug size, we recommend diameter not higher than 7 cm. for height, take into account when you
froth the milk, its volume will be double, so take a jug which height is according the quantity of milk to
froth.
4. Insert the froth device into the jug with milk (about 2 cm), then turn function knob to "
steam will start to come out. For frothing milk, move the jug up and down.
5. When you get the desired froth, stop steam function turning function knob to "
Note: clean steam outlet with a sponge or damp cloth immediately after using, take care not to burn.
6. Add frothed milk to espresso (prepared before), your cappuccino is ready. Sweeten to taste and, if you
desire, sprinkle the froth with cocoa powder.
7. Press ON/OFF push-button to switch off coffee maker.
Note: if you want to make another coffee, push heating button to "
to " " position.
Note: we recommend you let the coffee maker cooldown for 5 minutes before to make coffee again.
Otherwise you could get espresso coffee with burnt odor.
HEAT LIQUIDS WITH STEAMER
Steam wand (with no froth device) can be used to heat liquids as drinking chocolate or water.
1. Remove water tank and fill in without exceeding maximum level. Place water tank in coffee maker.
2. Plug coffee maker to mains.
3. Remove froth device.
4. Press ON/OFF push-button, heating indicator (red) will light. Press heating button to "
5. When ready indicator (ready) lights, put steam wand into cup with water or liquid you want to heat, turn
function knob to "
6. Steam starts to get out throw steam wand and it will heat the liquid. When it reaches desired
temperature, turn function knob to "
7. Unplug coffee maker if you aren't going to use again.

CLEAN AND MAINTENANCE:

1. Cut off power source and let the coffee maker cool down completely before cleaning.
2. Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip tray and
removable shelf regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for cleaning.
" position.
", wait for a moment until the ready indicator (white) lights.
" position.
" position to stop steam function.
" position.
" position and turn the function knob
".
" position,
14