Commissioning; Operation; Filling The Water Tank - Silvercrest SEM 1100 A2 Instrucciones De Uso

Commissioning

GB
MT

Operation

Filling the water tank

68
1) Clean the sieve holder
the drip grill 8 and the water tank 1 as described in the chapter "Cleaning
and Care".
2) Place the appliance on a level and heat-resistant surface. Ensure that a mains
power socket is in the vicinity.
8 so that the red fl oat can protrude through the recess 7
3) Insert the drip grill
in the drip grill 8.
4) Insert the plug into a mains power socket.
5) Proceed as follows before the fi rst use, so as to clean the internal pipelines:
6) Allow suffi cient water for about 5 cups of coff ee to fl ow through the appli-
ance. Refer to the chapter "Operation".
7) Let steam generate for about 30 seconds. Refer to the chapter "Operation".
NOTICE
► On the fi rst use it may be that the pump is already audibly working, noises
occur, but still no water is coming out of the appliance. In this case, turn
the steam control switch 2 in the direction "+" so that air can escape from
the pipelines of the appliance (the function rotary switch 5 stands at the
position „ "). After approx. 20 seconds the air will have escaped, the
noises disappear and water fl ows from the appliance.
NOTICE
► Use only fresh drinking water for making espresso/cappuccino.
1 upward and out, open the lid and fi ll it with water:
1) Pull the water tank
Fill it with water to at least the Min. marking.
Never fi ll it with more water than up to the Max marking.
2) Push the water tank
ance on the rails and sits fi rmly.
■ You can also fi ll the water tank
ance. Simply open the water tank lid and fi ll it with water from a bottle etc.
Ensure that no water runs beside the water tank 1.
w, the measuring spoon 9, the espresso sieve 0 q,
1 back into the appliance so that it slides into the appli-
1 without having to remove it from the appli-
SEM 1100 A2