Silvercrest SEM 1100 A2 Instrucciones De Uso página 79

5) Insert the sieve carrier
and place a cup under the sieve carrier w. As soon as the green heating-up
control lamp 4 glows, turn the rotary switch 5 to the position "
6) Let about 2 cups (coff ee cups) of water pass through and then stop the process.
7) Hold a container under the milk frother
8) Place the rotary switch
ing-up control lamp 4 glows. Slowly turn the steam control knob 2 to the
position "+ ". Allow the appliance to create steam for about 2 minutes.
9) After 2 minutes close the steam control knob
position "
10) Let the scaling agent take eff ect for about 15 minutes.
11) Repeat the steps 4 - 10 three times.
12) Then place the rotary switch
through until the water tank 1 is empty.
13) Rinse the water tank
to the Max marking.
14) Turn the rotary switch
up control lamp 4 glows.
15) Allow the water to run through.
16) Repeat the steps 13 - 15 three times.
17) Fill the water tank
18) Turn the rotary switch
19) Hold a container under the milk frother
knob 2 to the position "+" as soon as the green heating-up control lamp 4
glows.
20) After about 1 minute close the steam control knob
to the position "
NOTICE
► After 3 minutes the appliance will switch itself off automatically.
SEM 1100 A2
w, WITHOUT espresso powder, into the appliance
5 at the position " " and wait until the green heat-
" and switch the appliance off .
5 at the position "
1 with clean water and then fi ll it with clean water up
5 to the position "
1 with water once again.
5 to the position " ".
" and switch the appliance off .
z.
2, set the rotary switch 5 to the
" and let the solution fl ow
" as soon as the green heating-
z and slowly rotate the steam control
2, set the rotary switch 5
".
GB
MT
77