Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: Never use a wire,
needle, or similar object to clean
ODS/pilot. This can damage
ODS/ pilot unit.
Use a vacuum cleaner, pressurized air, or a
small, soft bristled brush to clean.
A yellow tip on the pilot flame indicates dust
and dirt in the pilot assembly. There is a small
pilot air inlet hole about 2" from where the
pilot flame comes out of the pilot assembly
(see Figure 22). With the unit off, lightly blow
air through the air inlet hole. You may blow
through a drinking straw if compressed air is
not available.
Air Passageways
Use a vacuum cleaner or pressurized air to
clean.
• If you remove logs for cleaning, refer to Installing Logs, page 14, to properly replace logs.
• Replace log(s) if broken or chipped (dime-size or larger).
20
CARE AND MAINTENANCE
ODS/PILOT
CABINET
LOGS
www.sureheat.com
Natural Gas
Burner
Pilot Air
Inlet Hole
Figure 22 - Pilot Inlet Air Hole
Exterior
• Use a soft cloth dampened with a mild soap
and water mixture.
• Wipe the cabinet to remove dust.
Propane/LP
Gas Burner
Pilot Air Inlet Hole
200083-01A
Publicidad
