Publicidad
Idiomas disponibles
Idiomas disponibles
3.- Safety precautions
3.1.- Place the tower only on a solid and flat surface.
3.2.- Check that the support system (SA) is fixed by the security trigger (R) and that the
tower is in a vertical position.
3.3.- Check that the tower is locked in its working position by means of the safety bolt
(M1, M2).
3.4.- When used out in the open, place the tower on hard ground and secure it against
wind force by means of steel cable braces. These steel cable braces must have a
minimum diametre of 4 mm.
3.5.- If necessary, the tower must be anchored to the ground with the appropriate
connecting device ACC/10.
3.6.- Do not use ladders on the tower nor lean them on it.
3.7.- Be careful with any cables, prominent objects etc. placed above the tower.
3.8.- Do not stand under the load.
3.9.- Do not move the tower when it is elevated or loaded.
3.10.- Before using the tower, check the state of the cable. This must be free of cuts and
fraying. Never use cables in bad condition.
3.11.- Never dismount the winch handle (W) or any element of the winch under any
circumstances.
3.12.- Once the tower is ready in its working position it is recommended to lock the
winch handle.
3.13.- The minimum load for a safe operation of the brake is 25 kg. The brake will not
function without this minimum load.
3.14.- Do not grease or lubricate the brake mechanism of the winch.
3.15.- Not permitted for use as passenger lift.
3.16.- For transportation it is necessary to retract all profiles and lock them with the
corresponding safety bolts (M1, M2).
Publicidad
