Recalling Stored Data - Medisana FTN Instrucciones De Manejo

GB
3 Operation
3.3 Measuring the temperature of an object
1. Move the selector switch
object temperature measurement mode
2. Press the ON/OFF button
The thermometer performs a self-test, where all the display
symbols are shown in succession.
3. Finally, the last registered reading is displayed along with the
M symbol (M = memory) for 2 seconds.
4. When you hear a short beep and the the symbol for the
measuring unit °C flashes, the thermometer is ready to take
the measurement.
5. To begin the measurement, point the sensor
of the object at a distance of no more than 5 cm. If it has
water, dust or dirt on it, remove this first so that the reading
is as accurate as possible.
6. Press the START button
the temperature is measured. The measurement is accompa-
nied by a series of beeps.
7. Release the START button
beep indicates the end of the measurement. Remove the
sensor from the measuring position. The display shows the
measured temperature.

3.4 Recalling stored data

The MEDISANA FTN infrared thermometer can store up to 30
results.
You can call up your stored data with a short press of the START
button , without having previously switched on the thermo-
meter with the ON/OFF button
the display next to "- - -". After a further short press of the
START button
display, followed directly by the last stored temperature reading.
The symbol M will flash below the unit of measurement.
With a further press of the START button
the result stored in memory slot "2". A total of 30 memory slots
are available, and these will be displayed in order if you continue
to press the START button
If a memory slot is empty, the symbol "- - -" will appear next to
it in the display.
24
to the bottom position to select
. The LC display
. The blue light
, memory slot number 1 will appear in the unlit
.
.
switches on and
after a few seconds. A long
. The symbol M will flash on
, you can call up
is activated.
at the middle