RIB AA30033 Manual página 31

A - CONNEXIONS
T1
T2
JC
JC
JB
JA
POWER
230 VAC
J1 L1 - N 230Vac 50/60Hz POWER SUPPLY
BLINKER (40 W MAX.)
J2 U-V-W CONNECTION TO JC CONTACTS OF THE CARD R2
J3 PED. BUTT. PEDESTRIAN OPENING CONTACT (NO)
A+ TEST +24Vdc SAFETY STRIP SELF-TEST POWER SUPPLY
LSC CLOSE LIMIT SWITCH THAT CUTS OFF THE MOTOR IN CLOSING
COM LIMIT SWITCH COMMON CONTACT
LSO OPEN LIMIT SWITCH THAT CUTS OFF THE MOTOR IN OPENING
J4 STOP STOP CONTACT (NC)
OPEN OPENING CONTACT (NC)
CLOSE CLOSING CONTACT (NC)
K. BUTT. SINGLE PULSE CONTACT (NO)
A+ ACCESSORIES POWER SUPPLY +24Vdc
A- ACCESSORIES POWER SUPPLY -24Vdc
SIGNAL GATE OPEN INDICATOR 24Vdc
COM COMMON CONTACT (common line for all the command and
safety inputs)
EDGE NC SAFETY STRIP CONTACT (NC)
J5 AERIAL RADIO ANTENNA
COM COMMON CONTACT (common line for all the command and
safety inputs)
PHOTO NC PHOTOCELLS CONTACT (NC)
J6 PROBE IS NOT AVAILABLE
S3
J5
TR1
TR2
J4
J3
MOTOR
CAPACITOR
NC: NORMALLY CLOSED CONTACT
NO: NORMALLY OPEN CONTACT
J7 J6
J7 ENCODER IS NOT AVAILABLE
J8 RADIO CONNECTOR FOR EXTERNAL RADIO RECEIVER 24Vdc
S3 PROG. PROGRAMMING BUTTON
TR1 LOW SPEED IS NOT AVAILABLE
TR2 TORQUE IS NOT AVAILABLE
(only CRX control board) DO NOT REMOVE ANY JUMPER!
SW
RADIO OTHERWISE THE OPERATOR WILL NOT WORK!
SW S1 DO NOT REMOVE THE JUMPER! OTHERWISE THE OPERATOR
WILL NOT WORK!
SW1 DIP-SWITCHES
SW2
SW3
CARD R2
T1 - T2 T POWER RELAYS FOR THE COMMAND OF THE MOTOR
JA R-N SINGLE PHASE POWER SUPPLY - NEUTRAL
CONTACTS FOR THE EARTH CONECTION
U-V-W MOTOR CONNECTION
JB L1-N SINGLE PHASE POWER SUPPLY FOR THE S1 CONTROL PANEL
TO BE DONE BY THE MANUFACTURER
JC X-Y-Z CONNECTION TO THE POWER RELAYS, TO BE DONE BY
THE MANUFACTURER
31
SW
RADIO
J8
SW1
IT IS COMPULSORY TO SET THE
DIP 13 OF THE CONTROL PANEL
SW2
IN THE ON POSITION.
SW3
SW
S1
J2
J1
G
B