Manual Presentation - AERMEC Novatherm DMH 220 Manual De Uso, Instalación Y Mantenimiento

DMH - DMH_C - DMV
The air, filtered through the filtering
section (1), is pre-cooled via the water
exchanger (2) coming from the radiant
system collector (8). In the subsequent
treatments in the sequence, the air
is further cooled and dehumidified
by the evaporator (3), it acquires
condensation heat as it becomes
warmer (5). Finally, it is post-cooled so
that it can be introduced into the room
at a temperature closed to the inlet
values. In the cooling versions, there
is no post-cooling and condensation
takes place directly in the water, rather
8
WATER INLET
ENTRATA ACQUA
1
AMBIENT AIR
ARIA AMBIENTE
2.

MANUAL PRESENTATION

This manual states the information and
that deemed necessary for transport,
installation, use and maintenance of the
DMH-DMV range dehumidifiers.
The user will find that which is normally
useful to know for correct safe installation
of the dehumidifiers described.
Failure to comply with that described
in this manual and inadequate
installation of the dehumidifiers causes
the annulment of the warranty that the
Manufacturer gives its dehumidifiers.
than in the air, thereby guaranteeing a
considerable sensitive load for the air
introduced.
The use of chilled water to pre-cool
the water is essential to ensure the
efficiency of the process, as this
minimises the electrical power used by
the refrigerant compressor (4).
15°C 18°C
WATER OUTLET
USCITA ACQUA
2 3
Moreover, the Manufacturer is not liable
for any direct and/or indirect damage
due to incorrect installation or damage
caused by units installed by unskilled and
unauthorised staff.
On purchase, check that the machine is
intact and complete.
5S
6
4
EN
DEHUMIDIFIED AIR
ARIA DEUMIDIFICATA
7
19