Publicidad
Idiomas disponibles
Idiomas disponibles
6. Function of Cruising
Speed Control - Tempomat
Your C2 Master knee/foot-controller is equipped
with a cruising speed control -Tempomat-.
This extended control system enables the operator to
select and store a given speed. A considerable facility
for maintaining a constant speed f. e. for work
underneath the microscope or for extensive work.
Cruising speed control 7 switched 'on'
- yellow LED is shining
- each speed which is kept more than 1 sec. is stored
- without pressing the knee/foot controller the motor
is running with the speed stored
- by operating the knee/foot controller again or by
pressing the switch 7 the stored speed is canceled
- to select a new speed please operate the knee/foot
control again until the desired speed is reached and
keep the control for about 1 sec. at this speed;
the new speed then is stored.
A stored speed can be canceled by switching off the
cruising speed control (yellow LED not shining).
7. Exchanging the rotary instruments
The chuck is opened, respectively, closed by
turning the outer sleeve 13 of the handpiece.
Caution:
Only ever exchange the rotary instrument with the
motor switched off!
With regard to the precision and service-life of the
chuck, an instrument must always be inserted into it
- even when the handpiece is not in use.
auf
zu
Operating the unit with a digital
display
knee and foot models only
Insert the plug on the digital display 19 into the
socket 18 in the rear of the unit.
When the unit is switched on, the digital speed
indicator shows the pre-selected maximum speed.
Once the motor is running, the actual speed
of the motor is displayed.
To save space, the digital speed indicator can be
placed under the handpiece rack or, if required,
adhered to a bench top with double-sided
adhesive tape.
table top unit
into the table top unit a digital display is integrated -
the display operates in the same way as
described above.
13
6
7
Publicidad
