Publicidad
Idiomas disponibles
Idiomas disponibles
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
After the unit is running you can connect the
3
appliances.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
It is strongly recommended to use a GFI (Ground Fault
4
Interrupter). It can significantly reduce the possibility
of injury if an electrical short occurs.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
A ground fault interrupter may ot be effective if
used on a generator that is not grounded.
When installing a GFI, be sure to follow all national
5
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
and local regulations, or call a qualified electrical
technician.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
1
Be sure your generator is connected at ground to avoid
an electric shock. The generator has a grounded terminal
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
for this purpose.
2
The ground wire should be made of # 10 AWG. A Smaller
wire should not be appropiated.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
3
The other end of the ground wire must be securely
fastened to an approved ground source. Refer to the
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
local regulations for grounding, Any rods or pipe used
for groundig must be driven eight feet deep or buried in
the deepest possible trench.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
BATTERY OPTIONAL
1
The DC outlet must be used to charge 12 volts battery.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
Make the connection following the cables from the
2
generator, black to -, red to +.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
1
Remove all electrical loads from the generator.
2
Rotate fuel shut valve into the ON position.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
3
Rotate the engine switch to the ON position.
4
Adjust the choke lever.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
5
Pull the starter rope with a brisk smooth motion.
6
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
Return the choke lever to the original position.
After each startup, allow the engine to run for 2 - 3
7
minutes with no load.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
Engine speed is preset to provide proper output
voltage. Never attempt to modify or adjust the
engine speed or output voltage.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
12
GROUNDING
STARTING
ADJUSTMENT
After initial start up the engine has to adjust, the first
1
25 hours are consider as adjustment period, during this
time, run your generator with less than 75% of load.
Always check the engine oil level before start up,
screw in the dipstick securely. Change oil the first
5 hours of work and after this period change it
every 25 hours.
SHUT OFF
Shut off and remove all electrical load devices from the
1
generator.
2
Allow the engine to run for 2 - 3 minutes with no electrical
loads.
3
Rotate the engine switch to the OFF position.
4
Close the fuel supply valve.
5
Verify that the generator has completely stopped.
Allow the unit to cool before storage.
6
CHARGING
1
The total loads should
n o t
e x c e e d
t h e
continuos power of
generator.
2
Reduce the loads if
the AC or DC turns
off. Push the Overload
Protection System to
start again.
NOTE:
The specified power
of the generator can
be calculated if you
m u l t i p l y v o l t s a n d
a m p s .
T h e r e s u l t
are the Watts. Never
exceed the maximum
power of the generator.
Refer to the owner´s
manual or labels to
k n o w t h e w a t t a g e
of the appliances or
tools.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT PREVIOUS NOTICE
Publicidad
