Bobbin
Winding
e Removing bobbin case
Remove the extension table from the machine by pulling
it to the left. Open the shuttle cover(_ by pulling down
the embossed part on the left of the cover.
Raise the needle to its highest position by rotating the
handwheel toward you.
(_
Shuttle cover
(_
Bobbin case
To remove the bobbin case(_from
the shuttle, pull open
the latch of the bobbin case. Pull the bobbin case straight
out of the shuttle.
9
• Bobbin winding
Release the clutch by pulling out the handwheel. This
will stop the needle from moving while you wind the
bobbin.
[] Draw thread from the spool.
[] Guide the thread around the thread guide.
[_Thread
through the hole in the bobbin from the inside to
the outside.
[] Put the bobbin on the bobbin winder spindle.
f
f
/
[]
[]
[]
\
[]
J
18