Installation On Support Structure; Recessed Hole - CAN FL Serie Manual De Instrucciones

GAS HOB UNITS COMBINED WITH RECESSED SINK ▪

INSTALLATION ON SUPPORT STRUCTURE

The appliance must be mounted on a support structure, made of material fire-retardant and resistant to
heat and with all of the sturdiness requirements indicated by the technical sector standards (for example
EN14749). The work table must be perfectly horizontal and perpendicular to all surrounding vertical panelling.
The area near the appliance could get very hot. Pay the utmost attention and do not place sockets, other
household appliances, power cables, piping and any other heat-sensitive or flammable material in this area.
ATTENTION!
The appliance must be installed in a room without air draughts which can have a negative
effect on combustion. The chosen installation position must also prevent the accumulation of
unburnt gases.
Comply with the sizes indicated in this manual. Any deviation could cause the temperature to rise excessively.
The surrounding surfaces must be able to withstand temperature rises admitted by standard EN30-1-1 and in
compliance with the design of this unit. All combustible material, such as curtains and shelves, must be kept
far away from the appliance. Check the admissible temperature of the materials used for the surrounding
surfaces to guarantee their compliance with the requirements of EN30-1-1.

RECESSED HOLE

The support structure must be provided with a suitable recessed hole. See the following table for the size
of the hole in reference to the purchased model:
sizes of recessed hole
[mm]
model a
FL1323
520
FL1324 520
FL1400 700
FL1401
700
FL1402 700
FL1410
700
FL1765
740
FL1766
740
FL1770 740
FL1780
740
85 mm
54
[mm]
b
320
320
320
320
320
320
325
325
325
325
128 mm
FL13XX
FL13XX - FL14XX
A
Details C
85 mm
FL14XX
FL series
135 mm
5 mm
C
8 mm