Gas Connection Procedure - CAN FL Serie Manual De Instrucciones

GAS HOB UNITS COMBINED WITH RECESSED SINK ▪

GAS CONNECTION PROCEDURE

The appliance is supplied with a gas train with a
smooth end section and free for at least 30 mm, fit
to house suitable press fittings. Proceed as follows
to perform the gas connection:
step
1 Connect the Ø 8 mm pipe to the clamp fitting of
the gas distribution network.
ATTENTION!
During the installation and connection
operations, the gas supply pipe of the
appliance must not be subject to twisting,
traction or any other mechanical stress
which could jeopardise tightness and
strength.
After connecting the equipment to the gas mains, check the fittings to make sure they are sealed by using
a solution of water and soap or a testing device for pressure leak tests. Gas installation technicians usually
have them.
ATTENTION!
It is absolutely prohibited to use naked flames to check tightness and to put the device into
service! If the test is satisfactory, light all the burners to make sure that the flame is regular
and stable.
ELECTRICAL CONNECTION (only for IGN version)
IGN versions are equipped with a low voltage spark generator (12 V DC) to light the burners, generally
installed on the metal bracket at the bottom of the hob unit. To connect the generator to the local power
mains, proceed as follows:
step
1 Connect the free end of the black conductor (-)
to the negative pole of the terminals of the mains
or of a battery.
2 Connect the free end of the black conductor (+)
to the positive pole of the terminals of the mains
or of a battery.
ATTENTION!
Any type of connection of the appliance
to a power mains other than 12V and in
direct current (DC) is strictly prohibited.
Any other connection can pose a severe
danger for the user of the appliance and
cause irreversible damage to the device
itself.
58
action
action
EQUIPMENT REQUIRED
Please note: the fittings are not supplied with the product. Their
supply and connection are the responsibility of the installer.
4 4 3
4 2
5 5 5 6
FL series
1
- +
12 V DC
1 Power cable positive pole
2 Power cable negative pole
3 Connection cable generator
button
4 Glow plugs fast-on housing
5 Glow plugs fast-on
connectors
6 12V DC (+ -) power supply
fast-on connectors