GreenWorks ST24L00 Manual Del Operador página 10

• Do not spray water onto the motor and electrical
components.
10.3 REPLACE THE SPOOL
1. Push the tabs (18) on the sides of the trimmer head at the
same time.
2. Pull and remove the spool cover (17).
3. Remove the remaining spool (19).
4. Clean dirt and debris from all parts. Replace spool if it is
worn or damaged.
5. Replace with a pre-wound spool, or replace the cutting
line.
6. Put the new spool in the spool cover.
English
Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
7. Put the ends of the cutting lines through the holes (21).
8. Extend the cutting line to release it from the guide slot in
the spool.
9. Push the tabs and install the spool cover onto the spool
housing (20).
10. Push the spool cover until it clicks into position.
10.4 REPLACE THE CUTTING LINE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of .08" (2.0 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
11
NOTE
NOTE
NOTE
EN