Makita AN611 Manual De Instrucciones página 6

Connecting air hose
1
005244
Lock the trigger. Slip the air socket of the air hose onto
the air fitting on the nailer. Be sure that the air socket
locks firmly into position when installed onto the air fitting.
A hose coupling must be installed on or near the tool in
such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
OPERATION
CAUTION:
Make sure all safety systems are in working order
•
before operation.
1. To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
005245
2. Pull the trigger first and then place the contact
element against the workpiece.
005246
No. 1 method is for intermittent nailing, when you
•
wish to drive a nail carefully and very accurately. No.
2 method is for continuous nailing.
CAUTION:
However when the tool is set to the "Intermittent
•
Nailing" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
1. Air fitting
2. Air socket
2
could occur, if contact element is allowed to
re-contact against the workpiece or the other
surface under the influence of recoil.
In order to avoid this unexpected nailing, perform
as follows;
A. Do not place the contact element against the
workpiece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds
after nailing.
For No. 1 method, set the change lever to the
•
"Intermittent Nailing" position.
For No. 2 method, set the change lever to the
"Continuous Nailing" position.
After using the change lever to change the nailing
method, always make sure that the change lever is
properly set to the position for the desired nailing
method.
1
2
005247
CAUTION:
Operating the tool without nails shortens the life of
•
the tool and should be avoided.
Air exhaust
005613
Air exhaust direction can be changed easily by rotating
the exhaust cover. Change it when necessary.
Jammed nailer
CAUTION:
Always lock the trigger, disconnect the hose and
•
remove the nails from the magazine before
cleaning a jam.
When the nailer becomes jammed, do as follows:
Open the door and magazine cap and remove the nail
coil. Insert a small rod or the like into the ejection port and
tap it with a hammer to drive out the nail jamming from
the ejection port. Reset the nail coil and close the
6
1. Intermittent
nailing
2. Continuous
nailing
3. Change lever
3
4. Trigger lock
4
1. Exhaust cover
1