HyleLab DX-100B Manual De Usuario página 8

Description
Filament
insertion hole
LED 1 (power up)
LCD Screen
LED 2 (status)
The filament
won't feed
unless this light
is green
Speed control
Introduction
Congratulations on purchasing your new HyleLab DX-100B 3D
pen.
5V power
This user manual is an integral part of the 3D pen. It contains
supply
important safety information and explains how the pen should be
used.
Please read all of the recommendations carefully before using your
3D pen for the first time.
The 3D pen must be used according to the instructions and for the
purposes specified. If you give or gift the product to someone else,
please ensure that you also provide them with this document.
+ Button :
Material /
How it works
temperature
selection
The pen pushes PLA or ABS filament (1.75 mm in diameter) up to
the nozzle, which is 0.8 mm in diameter, where it's heated up to
- Button :
between 180 and 230 degrees Celsius. The melted filament can
Material /
then be deposited to create either 2D or 3D shapes and artwork.
Temperature
selection
Backwards
The following information applies to both the pen and its AC
adapter.
Forward /
Touching the ceramic nozzle can cause burns. Please use the
extrude
silicone finger protectors provided.
(double-click)
We cannot be held responsible for any damage or harm that occurs
due to incorrect handling or failure to follow safety regulations.
This product can be used by children 8 years and over as well as
people who are physically or mentally handicapped, or have
sensory disabilities, or have no previous experience with this type
of product, but they must be supervised and/or fully understand
the risks associated with using the product.
Children must not be left to clean and maintain the pen
unsupervised.
Do not use this product if you notice any kind of damage.
Nozzle holder
Keep the product away from open flames and other heat sources.
Protect the product from humidity and liquids. Do not modify the
product in any way.
Ceramic nozzle
Safety information
EN