Kreg K4-INT Manual Del Propietário página 5

Kreg offers a complete line of pocket screws for every workpiece thickness and type.
Use this chart to select the correct screw length. All Kreg pocket screws are available
at your Kreg dealer or online at kregtool.com.
Screw Selection / Kreg Jig
NOTE Screw length is measured from bottom of the head to the tip of the screw.
Material
Thickness
1⁄2 in. [13 mm]
5⁄8 in. [16 mm]
3⁄4 in. [19 mm]
7⁄8 in. [22 mm]
1 in. [25 mm]
1-1⁄8 in. [29 mm]
1-1⁄4 in. [32 mm]
1-3⁄8 in. [35 mm]
1-1⁄2 in. [38 mm]
3
Position the Stop Collar
a. Place the step bit (G) in the setup gauge
on the jig base, aligning the step shoulder
with the dimension mark that matches
the thickness of your workpiece. Slide the
stop collar (H) onto the end of the bit and
position it against the end of the stop-collar
recess. Tighten the stop-collar set screw
with the hex wrench (I).
4
Adjust the Clamp Pad
a. Advance the toggle clamp (C) to the fully-clamped
position. Loosen the jam nut by rotating it on the
threaded clamp rod. Place your workpiece against
the drill guide. Rotate the clamp pad (D) until it is
pressing against the workpiece. Move the toggle
clamp handle to the unclamped position. Rotate
the clamp pad (D) another 1-1/2 to 2 turns to
advance it closer to the workpiece. Advance the
toggle clamp (C) to the fully-clamped position to
test that adequate clamping pressure prevents the
workpiece from moving.
Setting Chart
®
Screw Length
1 in. [25 mm]
1 in. [25 mm]
1-1⁄4 in. [32 mm]
1-1⁄2 in. [38 mm]
1-1⁄2 in. [38 mm]
1-1⁄2 in. [38 mm]
2 in. [51 mm]
2 in. [51 mm]
2-1⁄2 in. [64 mm]
Kreg Jig Setting
®
13 mm Mark
16 mm Mark
19 mm Mark
22 mm Mark
25 mm Mark
28 mm Mark
32 mm Mark
35 mm Mark
38 mm Mark
1-1⁄4" (32 mm)
5