Spark Arrester; Helpful Tips & Suggestions; Storing Your Engine - Honda GX630 Manual Del Propietário

SPARK ARRESTER (optional equipment)
In Europe and other countries where the machinery directive
2006/42/EC is enforced, this cleaning should be done by your
servicing dealer.
Your engine is not factory-equipped with a spark arrester. The
spark arrester is optional part. In some areas, it is illegal to operate
an engine without a spark arrester. Check local laws and
regulations. A spark arrester is available from authorized Honda
servicing dealers.
The spark arrester must be serviced every 100 hours to keep it
functioning as designed.
If the engine has been running, the muffler will be hot. Allow it to
cool before servicing the spark arrester.
Spark Arrester Cleaning & Inspection
1. Remove the spark arrester:
Remove the special screw from the muffler and remove the

spark arrester.

SPARK ARRESTER
2. Use a brush to remove carbon deposits from the spark arrester
screen. Be careful to avoid damaging the screen.
The spark arrester must be free of breaks and holes. Replace
the spark arrester if it is damaged.
3. Install the spark arrester and muffler protector in the reverse
order of disassembly.
MUFFLER
SPECIAL
SCREW
SPARK ARRESTER SCREEN
HELPFUL TIPS & SUGGESTIONS

STORING YOUR ENGINE

Storage Preparation
Proper storage preparation is essential for keeping your engine
trouble-free and looking good. The following steps will help to keep
rust and corrosion from impairing your engine's function and
appearance, and will make the engine easier to start when you use
it again.
Cleaning
If the engine has been running, allow it to cool for at least half an
hour before cleaning. Clean all exterior surfaces, touch up any
damaged paint, and coat other areas that may rust with a light film
of oil.
Using a garden hose or pressure washing equipment can force
water into the air cleaner or muffler opening. Water in the air
cleaner will soak the air filter, and water that passes through the
air filter or muffler can enter the cylinder, causing damage.
Fuel
Turn the fuel valve to the CLOSED or OFF position.
Engine Oil
1. Change the engine oil (see page 6).
2. Remove the spark plugs (see page 8).
3
3. Pour 5–10 cm (5–10 cc, 1–2 teaspoons) of clean engine oil
into each cylinder.
4. Turn the crank shaft several times to distribute the oil in the
cylinders.
5. Reinstall the spark plugs.
ENGLISH
9