Lindy 38348 Manual De Usuario página 5

User Manual
Installation and Operation
Overview
1.
Status LED:
Light on – HDBaseT connection and HDMI signal are active.

Light off – HDBaseT connection is active but there is no HDMI signal.

Light flashing – There is no HDBaseT connection.

2.
HDMI IN: Connect to an HDMI source device.
3.
IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
4.
IR OUT: Connect the supplied IR Transmitter cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
5.
HDBaseT OUT: Connect a compatible HDBaseT receiver using a single Cat.6 or above cable for all
data signals. Please do not connect to a network port.
6.
ON/OFF Switch: Turn ON/OFF the PoC function.
7.
DC 24V: Connect the 24VDC 1A PSU to an AC wall outlet if needed. The unit can be powered on also
connecting a HDBaseT Receiver with PoC function.
8.
Connect to a PC, serial controller or serial device via a phoenix block 3-way connection for the pass-
through transmission of RS-232 commands.
9.
SERVICE: Reserved for MCU updates.
Important! Before starting the installation, please ensure that all devices are powered off.
1. Connect an HDMI source device to the Transmitter unit using an HDMI cable.
2. Connect one end of the Cat.6 or above cable to the HDBaseT Out port on the Transmitter and the
other end to the HDBaseT In port of the Receiver. U/UTP or F/UTP installation cables are
recommended. For cable lengths please see the Specifications of this manual.
3. Use an HDMI cable to connect an HDMI display device to the HDMI output port on the Receiver unit.
4. Plug the DC power supply into either the Transmitter or Receiver (if using PoC function) and switch
on.
5. Power on the source device and display to complete the installation.
English