MPM MKE-14 Manual De Instrucciones página 29

180, 200, 220, 240 °C. The temperature can be re-adjusted at any time.
CAUTION! If you do not declare the heating time, the appliance will automatically switch off
after 120 minutes.
HEATING TIME – from 0 to 180 minutes. Use the timer function touch button (2g) to
select the timer – a LED will light up over the touch button Use the touch buttons (2d) to
set the heating time in minutes ("+" adds 10 minutes, while "-" reduces the time minute by
minute) and while a moment – the configured value will be lit up continuously, which means
the timer has started working. The cooker will then alternately display the passing time and
power or temperature. Once the configured time is up, the heating plate will be deactivated
and a sound signal will be heard.
KEYBOARD LOCK FUNCTION – in order to lock the keyboard, simultaneously press the
parameter value change buttons (-/+). In order to unlock the keyboard, press and hold the
parameter value change buttons (-/+) for a moment.
5. If you lift the pot/pan or move it away from the cooking zone, the heating process will stop au-
tomatically ("EO" message). The hob will resume the process using the previous settings if you
put the pot/pan back on the heating zone within 60 seconds. Otherwise the hob will switch off
automatically.
6. You can stop the heating process at any moment using the "ON/OFF" button (2a).
CAUTION! The heating plates can be hot after use. Do not touch.
7. When the heating process is over, take the pot/pan away from the heating zone but do not unplug
the hob from the mains while the fan cooling the inside of the appliance continue to work. You can
safely unplug the hob only after the cooling fan stop.
8. When the plates cool down, clean the appliance (see: "CLEANING AND MAINTENANCE").
ERROR TABLE: CAUSES AND SOLUTIONS
ERROR CAUSE
CODE
E0 No pot/pan in the heating zone. Incorrect cookware.
E1 Electrical failure/ short circuit.
E2 Damaged temperature sensor.
E3 Power supply voltage too high.
E4 Power supply voltage too low.
E6 Cooling fan(s) damaged.
SOLUTION
Put a pot/pan in the heating zone. Make sure your
cookware is compatible with induction hobs.
Contact an authorised service centre.
Contact an authorised service centre.
Make sure the power supply parameters correspond to
the ones presented on the product's nameplate.
Make sure the power supply parameters correspond to
the ones presented on the product's nameplate.
Turn off the appliance. Wait until it cools down, clean
the airflow grills and turn on the hob again. Contact an
authorised service centre.
EN
29