Mounting And Installation - Intermatic ET9500 Manual De Instrucciones

Mounting and Installation:

1. Install mounting brackets to enclosure. (See instruction sheet included within included brackets)
2. Securely mount enclosure to desired location using hardware capable of supporting the ET9500.
Note: Unit must be mounted vertically (upright) on a surface or structure capable of supporting the unit. Space must be provided
for the enclosure door to fully swing open.
3. Remove and retain dead front and hardware from the ET9500.
4. Choose and remove the selected knockout(s) for AC input and gateway connections from enclosure.
Note: There are ½ inch and ¾ inch knockouts available. If a ¾ inch knockout is needed, remove the ½ inch knockout first and the
¾ inch outer ring. Smooth edge if necessary.
5. Use appropriately rated fittings for installation.
6. Strip supply wires to ½".
7. Connect wires to proper terminals on the gateway and firmly tighten making sure no insulation is crimped in
terminal.
8. Connect ground wire to ground screw and firmly tighten making sure no insulation is crimped in terminal.
9. Replace dead front and secure with screws removed earlier.
10. Connect ethernet or RS 485 cable to the Gateway module. See included Quick Start Guide for connection guidance.
If within the warranty period specified, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended
to the original purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which
have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or
lamp bulbs, LED's and batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal
costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. ALL IMPLIED WARRANTIES, INCLUDING
THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND
SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION
MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased or (b) completing a warranty claim online at www.intermatic.com. This warranty is
made by: Intermatic Incorporated, Customer Service 7777 Winn Rd., Spring Grove, Illinois 60081-9698. For warranty service go to: http://www.Intermatic.com or call 815-675-7000.
LIMITED THREE-YEAR WARRANTY
1/2 inch
RS 485
CONNECTION
- +
G