Bimar VM45 Folleto De Instrucciones página 14

Attention: any stickers or advertising material applied to the grid removed before using the
appliance. The manufacturer declines all responsibility in case this is not safe working
practices will be respected.
• Before connecting the appliance, check that the voltage values shown on the data plate
correspond to those of the electricity supply network. In the event of incompatibility
between the electric outlet and the plug of the appliance, have the outlet replaced with
another more suitable type by professionally qualified personnel, who will make sure that
the section of the wires of the outlet is appropriate for the absorbed power of the product.
In general, the use of adapters or extension cords is not recommended; if their use is
indispensable, they must conform to existing safety standards and their current capacity
(amperes) must not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2
meters) to avoid the risk of it falling in.
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct
the air intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Do not place the wall fan into the room to avoid the back-flow of gases from the open flue
of gas or other fuel-burning appliances (for duct and partition fans).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not
twisted or wrapped around the appliance.
1) Front grille
2) Fan attachment ring nut
3) Fan
4) Grille attachment ring nut
5) Rear grille
6) Motor shaft
7) Body
8) On-speed button
9) Base
10) Screw Adjustable up/down
tilt
11) Screw fix the grids
12) Mounting plate
13) Off button
14) Oscillation button
15) Mode button
16) Timer button
14/48