Babyauto Nico LB 513 Manual De Uso página 21

6. Make sure the vehicle's safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle's
safety belt or prevent the installation of the seat in any way. To
release your child unbuckle the vehicle safety belt as described in
the instructions.
Ensure that the belt has no slack.
4. HOW TO INSTALL THE CHILD CAR SAFETY SEAT. GROUP 2 & 3.
WARNING
Before installing the seat it is necessary to remove harness straps,
crotch straps and lap straps (Chapter 6). Subsequently, install the
seat belt height adjustment as shown below.
1. Place the child seat on the seat of the vehicle, ensuring it is pressed
firmly against the back of the vehicle seat (4.1).
2. Place the child in the child restraint seat with height adjuster Q at
the child's shoulders (4.2).
3. Fasten the belt, ensuring that the lap belt goes through the guide
under both armrests and that the diagonal shoulder belt passes
through Q height adjuster on the childrens shoulder and under the
armrest that is next to the vehicle anchor point. Fasten the seat
belt into the vehicle´s buckle until it "clicks", making sure the child
seat is properly installed (4.3 y 4.4).
4. Make sure the vehicle's safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle seat
belt or prevent the installation of the seat in any way. To release
your child unbuckle the vehicle safety belt as described in the
instructions.
Ensure that the belt has no slack.
Group 1/2/3
Use Group 2&3 only from approx.
4 to 12 years of age (15-36 kg)
www.babyauto.com
EN
21