Publicidad
• Place the equipment on a dry, firm, flat and level surface.
• Connect one end of the suction hose (not included) to
the water inlet of the motor pump (A) and the other end
of the hose to the filter (B).
• Connect the discharge hose (not included) to the water
outlet of the motorized pump (C).
CAUTION
• All connections must be secured with
suitable clamps (D).
CAUTION
• The hoses must be continuous
without kinks in their structure. The length of the suction
hose should not exceed the length allowed for the pump
to operate properly.
• It is essential to use the filter (B) to
CAUTION
prevent large particles from entering the system and
damaging the pump.
• Immerse the end of the suction hose with the filter
attached in the water source to a minimum depth of 49 ft
Oil supply (A)
• Place the equipment on a flat, level surface.
• Turn and remove the oil fill plug.
• Use 4-stroke engine oil. SAE 10W-30 high temperature oil is
recommended.
• Replace the plug without screwing it on and remove it to
check the oil level on the plug dipstick.
• When the oil level matches the mark on the dipstick,
tighten the plug to prevent leakage.
CAUTION
• Check the oil level before each use. If
necessary, add oil until the level matches the mark on the
plug dipstick.
Fuel supply (B)
• Place the equipment on a flat, level surface.
• Clean and dry around the fuel cap.
• Remove the fuel cap.
• Without removing the filter and with the help of a funnel
fill the tank slowly.
to allow expansion of the fuel and avoid spillage.
• Clean up any fuel spills.
• Cap the fuel tank.
• Clean up all spillage before lighting.
8
ENGLISH
CAUTION
Do not fill completely
Installation
C
A
B
Oil and fuel
B
A
D
Mark
Publicidad
