Craftmade Bellows IV BW414 Guia De Instalacion página 5

4. Wall Bracket Installation. (cont.)
Thread electrical wires from wall through the
opening in the middle of the wall bracket.
Position wall bracket over pilot holes and
insert a lock washer, a flat washer and a screw
(provided in hardware pack) into each hole.
Tighten all screws securely with a Phillips
screwdriver.
WARNING: It is very important you use the
proper hardware when installing the wall
bracket as this will support the fan.
Thread electrical wires through the canopy.
Pull extra wire slack completely through the
canopy.
5. Wiring.
Make sure all electrical connections comply
with Local Codes or Ordinances and the
National Electrical Code (or the Canadian
Electric Code). If you are unfamiliar with
electrical wiring or if the house/building wires
are different colors than those referred to below,
please use a qualified electrician.
Connect GROUND (GREEN) wire from wall
bracket to BARE/GREEN wire from wall with
wire connector provided.
Connect WHITE wire from fan assembly to
WHITE wire from wall with wire connector
provided.
Connect BLACK wire from fan assembly to
BLACK wire from wall with wire connector
provided.
Connect BLUE wire from fan assembly to RED
wire from wall with wire connector provided.
lock washer
flat washer
page 5
screw
screw
wall
bracket
canopy
WHITE WHITE WHITE WHITE WHITE WHITE
BLACK BLACK BLACK BLACK BLACK BLACK
BLUE RED
GREEN BARE
wiring