Publicidad
Idiomas disponibles
Idiomas disponibles
Pressure washing with volatile, flammable, or corrosive liquids could cause pressure
washer damage, fire, or explosion resulting in severe injury and/or death. To avoid these
hazards, use only approved soaps and chemicals, do not attempt to pressure wash with
volatile, flammable, or corrosive liquids, and NEVER use bleach.
1.
Attach the open end of the soap hose to the
barbed fitting on the pump.
2.
Place the filtered end of the soap hose into a
container of soap.
3.
If the engine is running, make sure the trigger
lock is in the locked position before removing and
installing nozzles.
4.
Insert the black nozzle into the spray wand per the
Nozzle Installation section of this manual. NOTE:
Soaps will not siphon if the black soap nozzle is
not installed on the spray wand.
After using soap, place the filtered end of the soap hose into a container of clean
5.
water and run pressure washer drawing clean water through the hose and pump
until the system is thoroughly rinsed. If soap or other chemicals remain in the pump,
the pump could be damaged. Pump damage from soap or chemical residue is not
covered under warranty.
Page 13
USING CHEMICALS
NOTICE
VOLATILE LIQUIDS
SOAP
Publicidad
