Publicidad
housing, fix clip to housing with screw, then insert hob into cabinet/work surface.
Fix hob to cabinet: Insert the hob into the cabinet/work surface as below
diagrams, the mounted clips on the sides can secure your hob sturdily.
Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard,
or a single-pole circuit breaker. The appliance has a large power rating and
must be connected to electricity by a Qualified Electrician.
Notes:
1. If the cable is damaged or needs replacing, this should be done by an
after-sales technician using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omni polar
circuit breaker must be installed with a minimum gap of 3mm between the
contacts.
3. The installer must ensure that the correct electrical connection has been made
and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by qualified technician.
Cautions
1. The hob must be installed by qualified personnel or technicians. Please
never conduct the operation by yourself.
2. The electric hob shall not be mounted to cooling equipment, dishwashers and
rotary dryers.
3. The electric hob shall be installed such that better heat radiation can be ensured
to enhance its reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be heat resistant.
12
Publicidad
