Publicidad
Idiomas disponibles
Idiomas disponibles
5
USAGE CONDITIONS
For your own safety, as protection for others, and to avoid damage to the equipment, read carefully
the usage recommendations.
1. Before working, to be sure the hose joint nut is fastened to the motor (screwed to left).
2. Be sure the poker is well screwed to the flexible shaft (screwed to left).
3. Do not work with flexible shaft with big bends.
4. Do not overlubricate the shaft.
5. Do not keep working the poker out of the concrete more than 5 minutes.
6. Do not restrict the movement of the poker during the work.
7. Do not stop the poker inside the concrete.
8. Change the wear parts to avoid damage to the internal parts. (Check wearing table for the poker)
9. Do the maintenance with the kinds and quantities of recommended lubricants.
6
OPERATION AND MAINTENANCE
6.1 BEFORE START
1.-
2.-
3.-
4.-
5.-
6.-
7.-
8.-
9.-
6.2 GETTING STARTED.
Read item 5 USAGE CONDITIONS
6.3 SHAFT CONECTION TO POWER UNIT
Power unit is designed to facilitate a quick and safe connection to flexible shaft.
CONNECTION PROCEDURE: (Connect with engine off).
1. Connect the transmission shaft to the square motor connection
2. Screw plastic nut of shaft to aluminium thread of power unit . (Be aware of nut turns left and not
tool is required)
CONNECTION CHOICES:
Flexible shaft length:
- Up to 6 mts (TDX 0,6m, TDX 1m, TDX 1,5m, TDX 2m, TDX 5,5M, TDX3m, TDX 4m, TDX5m and
TDX 6m)
Vibrator diameter:
- Up to 58 mm diameter (AX25, AX32, AX40, AX48 AND AX58)
KAMEL - FLEXIBLE SHAFT AND POKERS
TDX1m, TDX1-5m, TDX2m, TDX3m, TDX4m, TDX5m, TDX6m
Before working, make sure that all the security devices are operating under normal
conditions.
Read the engine manufacturer manual.
Do not work in rooms with scarce ventilation.
Make sure there is no flammable good near to the escape.
Check the petrol level in the reservoir (use always unleaded gas in 4 stroke engines).
Check the oil reservoir of the motor is full (see engine manual) in the 4-stroke engine
(SAE10W40).
Check all the bolts are well tighten.
Start the motor, regulate the speed with the accelerator until it reaches a good vibration.
When a defect or a malfunction has been detected, endangering the use of this machine
or not, stop the work and make the correspondent maintenance to avoid any danger or
bigger damage.
KAMEL - AX25, AX32, AX40, AX48, AX58
en
7
Publicidad
